Problem with Xentry connection

[pk.evolved]

I'm trying to connect to w204. I start the connection, it recognizes ignition, reads chassis number (so i know that it's not cal870 error) and all steps till the step "The codings of the central control units are read out" and then it says that there is no ignition (and I have to check it in the check box). After all steps are done it says that there is no connection between MUX and the car.
I connected to the car with DAS 09/2008 and the MUX communicated ok, so I know it's Xentry issue.

I'm using Xentry 07/2011

[phatty123]

Did you make any progress with this?

[Bigovic]

I'm trying to connect to w204. I start the connection, it recognizes ignition, reads chassis number (so i know that it's not cal870 error) and all steps till the step "The codings of the central control units are read out" and then it says that there is no ignition (and I have to check it in the check box). After all steps are done it says that there is no connection between MUX and the car.
I connected to the car with DAS 09/2008 and the MUX communicated ok, so I know it's Xentry issue.

I'm using Xentry 07/2011
@pk.evolved
Check your OBDII Cable the Pin8
Use the 38 Pin Cable and try with different car and tell me if you have the Problem more. IF NOT CHECK YOUR OBDII CABLE

by Goran

[snelle rabbit]

have exact the same problem with xentry 03/2012
das works fine,

other labtop same hardware (same type laptop) das and xentry both work fine (03/2011 version)

so it has to be a xentry software problem

someone has same problem and/or solution yet?:pepsi:

[willxxx]

I have the same problem. Someone can give me a hint?

many thanks in advance.

[snelle rabbit]

I have the same problem. Someone can give me a hint?

many thanks in advance.


is youre multiplexer serial not blocked ?

mine is not blocked and still have this problem,

[cardiagpt]

try chang cal.sli in
F:\programme\Xentry\bin\llist and make it Read Only.

regards

[snelle rabbit]

try chang cal.sli in
F:\programme\Xentry\bin\llist and make it Read Only.

regards


today had give it an other try.
changed the cal.sli in F:\programme\Xentry\bin\llist
and made it Read Only.
exactly the same problem

now i changed cal.sli in F:\programme\Xentry\bin
with an orginal one from xentry 03/2011 with some other files
now xentry works normal. problem solved



i think if i only changed cal.sli in F:\programme\Xentry\bin
it will work too. will try it this week and let it know.

this is tested with orginal non blocked multiplexer

thanks