View Full Version : escort diesel 1998 lost keys
bazbaz
11th December, 2011, 10:23 PM
hello , all keys have been lost for van i've managed to make a new key to open locks but now need to produce transponder or immo off , i have sbb , zedbull clone and x prog what are my options ,i know i can just put live to back of pump but i wont learn anything that way
thanks in advance
ninja123
11th December, 2011, 10:31 PM
SBB CAN DO IT, BUT T300 IS BETTER
You will need 3 diifferent transponders, used ones are ok.
just run through the procedure from your programmer and all will be good.
ninja
bazbaz
11th December, 2011, 10:45 PM
will i need to precode them with my zedbull ? and which transponder will i have to use 4C ?
thanks for the help
DottoreBL
12th December, 2011, 11:16 AM
u can used old 4c from any Ford and programe it
gokey
12th December, 2011, 02:21 PM
no need precoded ransponder
bazbaz
14th December, 2011, 01:14 AM
hello , i've ran through procedue that programmer shows , insert master then 2nd then 3rd key , tested keys in order they were programmed (not including master) but they're not programmed ? gonna try again tommorrow with full charge on van as sbb was showing 10.5 volt do you think this could be the problem
thanks
keygargoil
14th December, 2011, 02:12 AM
hello , i've ran through procedue that programmer shows , insert master then 2nd then 3rd key , tested keys in order they were programmed (not including master) but they're not programmed ? gonna try again tommorrow with full charge on van as sbb was showing 10.5 volt do you think this could be the problem
thanks
you do need good voltage also if it shows up 0 keys or the faults may say insuficiant keys programmed just cycle another chip in each chip you cycle the led in the clock will come on solid until the 3rd key is programmed then it will go out if the light constantly flashes its the wrong chip you need red t3 chips not blue t7 chips
bazbaz
17th December, 2011, 12:06 AM
tried again tonight with full charge on the van still wont start ,even though its showing 3 keys programmed ? , when i insert 1st the led goes off same with 2nd but when i try to put a 3rd key to prog the led starts to flash rapidly ?also was showing not enough keys programmed so i cycled chips as suggested still no luck any ideas
problem sorted
thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.