View Full Version : 29F400BB BDM100?
JaboJG
15th December, 2011, 09:10 PM
Can BDM100 clone read the 29F400BB which is in the Marelli IAW48P2.31?
Car is a Citroen C5.
avtonega
15th December, 2011, 09:34 PM
NO
...............................
JaboJG
15th December, 2011, 09:39 PM
Very difficult getting a tool to read this ECU.
Bought european MPPS v12, Galletto and BDM100.
Do I need to buy a Lexia v3?
kazikk
15th December, 2011, 09:42 PM
Desolder flash and read with programmer.
JaboJG
15th December, 2011, 09:44 PM
I could do that. Which programmer would you recommend?
gzk
15th December, 2011, 09:47 PM
gq4X willem etc...
alfy
15th December, 2011, 11:17 PM
Have you tryed with Galletto 1260 or magpro2 on bench or OBD?
Citroen IAW48P 2 29F400BB...
JaboJG
15th December, 2011, 11:44 PM
Have you tryed with Galletto 1260 or magpro2 on bench or OBD?
Citroen IAW48P 2 29F400BB...
Tried Galletto 1260 and MPPS v12 via OBD.
MPPS has no connection and IAW48P2 is not listed as compatible with it but Galletto displays ECU info as 2 lines of hex data then fails on read with SK2 error, even though it should be compatible.
Next step I suppose should be trying on bench.
agabna
16th December, 2011, 01:48 AM
Tried Galletto 1260 and MPPS v12 via OBD.
MPPS has no connection and IAW48P2 is not listed as compatible with it but Galletto displays ECU info as 2 lines of hex data then fails on read with SK2 error, even though it should be compatible.
Next step I suppose should be trying on bench.
hello
rading in bench is better
you can use beeprog from elnec
pablo1971
16th December, 2011, 08:16 PM
isnt the 29f readable by getting the chip in boot mode.like the vag...
JaboJG
16th December, 2011, 09:07 PM
Can't find any info about a 48P2 boot mode. Spoken to other tuners and searched the forums.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.