View Full Version : DASH CONNECTION VITO 110D
CIRCUIT.FR
19th December, 2011, 12:46 PM
HI
I need control dash for VITO 110D year 1998 (638).
Dash is a VD0 with two connector (white and black).
I would like find connection for control speed gauge in bench.
Thanks
hcip
19th December, 2011, 02:19 PM
Get a mirror,
Place the dash in front of a mirror so you can see the needles if it will move
Power up the dash
Connect the one wire of your pulse generator at the negative side
touch momentarily the other wire of pulse generator for each pin of dash
if you see in the mirror that the needle up, then you got the speed control pin
This procedure will not harm your dash
Best Regards:manuflag:
CIRCUIT.FR
19th December, 2011, 03:27 PM
sorry
But I haven't car...only dash
hcip
19th December, 2011, 05:30 PM
sorry
But I haven't car...only dash
yes you need to power up the dash on the bench and not into the car
CIRCUIT.FR
20th December, 2011, 12:12 AM
OK
BUT I need pin connection..........to connect it and test....
altera
20th December, 2011, 07:51 PM
in black connector
pin4 gnd
pin5 +12
pin7 +12
speed is in 1 or 2 not sure......one of them is GND
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.