please need immo off ecu bosch audi me7.1.1

[mouss]

hello;

Please can someone help me i need immo off on this ecu audi bosch number is 0261 208 793 ME7.1.1, file is attached.
EPROM IS 5P08 or 95P08 it's same.
I think i must read flash from 29F800BB too??

THANK VERY MUCH

[dgmcan]

Hi!

If the ECU is ME7.1.1 the eeprom is 95040 or 24c04

[lupu_sandu]

Your file off.

dgmcan: This is 7.1.1 ECU so have 95080 memory. ME 7.5.x have 95040.

[mouss]

hi
thank for all but i must do flash for immo off or now is good??

thank

[haroutioun]

hi
thank for all but i must do flash for immo off or now is good??

thank
Hi,
just write file of (lupu_sandu) and the car start %100.
good luck...

[mouss]

thank for all car started but i have much options not work i can't turn rigt and left with direction is bloked etc!!! can i have a good file with option for car or not

thank again

[zoro1]

Read the car for errors with vcds or vag com,post errors.

[mouss]

CAR IS AUDI A3 3.2L ERROR IS :

1) GLASS NOT WORK
2) ESP LIGHT TURN ON
3) WINDSCREEN WIPER NOT WORK
4) LIGHT steering wheel TURN ON IN DASH

THANK FOR ALL

[ruslan.v]

CAR IS AUDI A3 3.2L ERROR IS :

1) GLASS NOT WORK
2) ESP LIGHT TURN ON
3) WINDSCREEN WIPER NOT WORK
4) LIGHT steering wheel TURN ON IN DASH

THANK FOR ALL


Send log file from VCDS.

[ezenigbo]

please can i have pass to this immo off?

[james44000]

Hello all

I have a problem to immo off my ecu (a3 3.2)
bosch ME7.1.1 0 261 208 793
Chip 95080

Thanks to all

[dgmcan]

Hello all

I have a problem to immo off my ecu (a3 3.2)
bosch ME7.1.1 0 261 208 793
Chip 95080

Thanks to all

Try this file:

Please, report...

[james44000]

the car don't start:banghead:

[TravisG123]

Hello I have a 2005 beetle 1.8 turbo ME7.1.1 and I can't find which eeprom to remove can someone help?

[TravisG123]

Need a immo off situation

[kiszka]

Hello I have a 2005 beetle 1.8 turbo ME7.1.1 and I can't find which eeprom to remove can someone help?
the ecu number would be useful

[TravisG123]

It's a
06A 906 032 QS

[TravisG123]

im brand new here
thanks for help im still learning how this site works
Thank You

[peko]

hi friends


i need immo off about this A3 3L2
kess crach it
i write ori but not start

0261S04226

eeprom inside is 95160

thanks for your help

[rafal]

here................

[peko]

here................

engine not start
are you sure your off ?

[kiszka]

engine not start
are you sure your off ?
......................
https://mega.nz/#!UyRnSQrY

[peko]

......................
https://mega.nz/#!UyRnSQrY

not start friend

[kiszka]

not start friend
it should work
I think you have a malfunction in the car
what are the errors in ecus

[peko]

it should work
I think you have a malfunction in the car
what are the errors in ecus

car go here ok
kess writing to 50% after crach

i remove ecu ktag R/W ok
i unsolder flash 29F800BB to write ori savec with kess 1024ko ( kess full read flash :peaceful: )

and now no way to write ori via obd , kess always lock 50% and no more

i read in other forum guy with same trouble but no say solution, he said :
" No that wasn't possible to upload file through OBD, tried couple time and Kess stucked at 50%. After unsuccessfully programming ECU saved same information in eeprom, which wasn't allowing to start the engine.
After modification in eeprom file problem gone. "

so now ... engine not start

[morgano]

Flash back working original in boot mode, then repeat the procedure by obd. It should put ecu out of programming mode.

[kiszka]

car go here ok
kess writing to 50% after crach

i remove ecu ktag R/W ok
i unsolder flash 29F800BB to write ori savec with kess 1024ko ( kess full read flash :peaceful: )

and now no way to write ori via obd , kess always lock 50% and no more

i read in other forum guy with same trouble but no say solution, he said :
"No that wasn't possible to upload file through OBD, tried couple time and Kess stucked at 50%. After unsuccessfully programming ECU saved same information in eeprom, which wasn't allowing to start the engine.
After modification in eeprom file problem gone. "

so now ... engine not start
which you finally have ecu
022906032GP
022906032LP
also give me org eeprom without your modifications

[peko]

Flash back working original in boot mode, then repeat the procedure by obd. It should put ecu out of programming mode.

i not think this way
i will test tomorrow

thanks ;)

[peko]

which you finally have ecu
022906032GP
022906032LP
also give me org eeprom without your modifications

is 022 906 032 GP
have you eeprom file to compare

[morgano]

is 022 906 032 GP
have you eeprom file to compare

This is your eeprom with immo off and some other changes.

Try it to see if it allow you to start the car after have flashed good original via bootmode.

Good luck

[kiszka]

is 022 906 032 GP
have you eeprom file to compare
what about the original file without your modifications
You have

[peko]

what about the original file without your modifications
You have

yes i have flash ori
but not eeprom before crash

[kiszka]

yes i have flash ori
but not eeprom before crash
I just need the original immo data
files is damaged
I think I have a cure

but first save the MORGANO file if it works
I won't waste time copying, his

[peko]

ok thansk friend

i will test it tomorow when i come back to office

seem eeprom stay locked in boot programming ...

big thanks ;)

[peko]

ecu hw sw

thanks friends for your help ;)

[peko]

hi friends

no way to start engine

i see gearbox ligthting in dash (all gear ligth on/off)

[morgano]

hi friends

no way to start engine

i see gearbox ligthting in dash (all gear ligth on/off)

Are you sure your original is 100% ok?

Do you have diagnose? Can see dt codes?

[kiszka]

the goal has been achieved

[peko]

yes solved :champions:

thanks friends for your help
big thanks to kiszka found refund eeprom :celticparty:

[zeh212]

Hello all ..

I have exactly same problem kess v2 crash after 50% writing.

I have ori flash file
Try to write ori with recovery but always stuck at 50%...

022906032LP ME7.1.1 On Audi A3 3.2 V6 2008 car not start.

Should I only write good ori eeprom ?
I don’t have my ori eeprom because it crashed..

Can you help me please ?
Can I do something with VASPC ODIS ?

[zeh212]

736170
here is the screen of ECU with kess

[kiszka]

736170
here is the screen of ECU with kess
read eeprom ecu with programmer and share

[ctrlf9]

Hi!

If the ECU is ME7.1.1 the eeprom is 95040 or 24c04

hi i have a3 3.2 with corrupted eeprom can i write your immo off solution?

[kiszka]

hi i have a3 3.2 with corrupted eeprom can i write your immo off solution?

put the original file, then I will check crc

[ctrlf9]

put the original file, then I will check crc

i can read eprom but the car now dont start , i dont know if the eprom is ok or damage.
the engine is on a golf mk3

[kiszka]

i can read eprom but the car now dont start , i dont know if the eprom is ok or damage.
the engine is on a golf mk3

let me check you out

[ctrlf9]

let me check you out

ok thanks, tomorrow i read and post

[ctrlf9]

let me check you out

i have desolder eprom read with carprog as 95p08 (eprom is 5p08c3)

[kiszka]

i have desolder eprom read with carprog as 95p08 (eprom is 5p08c3)

https://mega.nz/file/0i5kBTaS