Ford Transit 2.5TD EPIC

[Crash-100]

Ford Transit 2.5TD EPIC 1996 not start, led immo flash 32.
ECU 95VB-9J464-ZF, can help with immooff.
In ECU 11K4 in immo TMS

[Crash-100]

the problem is solved

[Krotov_FSB]

how problem is solved?

[3abas27]

how problem is solved?
HOW DID YOU SOLVE YOUR PROBLEM ?
NEED YOUR HELP FREIND

[Crash-100]

where your dump

[3abas27]

where your dump
HERE MY DUMP
BUT ONLY TMS DUMP I TRY TO READ ECU BUT NO SUCCES WHATS GOOD PROGRMMER CAN READ IT IN CIRCUIT?
MY PROBLEM IS SYNCHRO
KEYS ARE PROGRMMED IN IMMO
PLZ NEED YOUR HELP
THANKS

[3abas27]

HERE MY DUMP
BUT ONLY TMS DUMP I TRY TO READ ECU BUT NO SUCCES WHATS GOOD PROGRMMER CAN READ IT IN CIRCUIT?
MY PROBLEM IS SYNCHRO
KEYS ARE PROGRMMED IN IMMO
PLZ NEED YOUR HELP
THANKS
I TRIED READING ECU WITH BOTH PROGRMMER UPA AND XPROG
LIFTING ALL PINS
UPA IGET VDD/VCC OUT OF RANGR
XPROGM I GET DEVISE SILENT TIME OUT ERROR
I TRIED WITH CONFIGURING OSCILLATOR TO 556000 AND OTHERS SAME RESULT

[3abas27]

I TRIED READING ECU WITH BOTH PROGRMMER UPA AND XPROG
LIFTING ALL PINS
UPA IGET VDD/VCC OUT OF RANGR
XPROGM I GET DEVISE SILENT TIME OUT ERROR
I TRIED WITH CONFIGURING OSCILLATOR TO 556000 AND OTHERS SAME RESULT
finally a freind help by reading ecu dump
here is dump ecu
plz verify if my synchro is ok,?
keys are ok
happy weekend

[3abas27]

finally a freind help by reading ecu dump
here is dump ecu
plz verify if my synchro is ok,?
keys are ok
happy weekend
soory forget attachement

[Crash-100]

try this must work

[3abas27]

try this must work
thanks freind
tomrrow i will make test and make info

[mariusbarcelona2010]

PostPosted: Sun November 25, 2012 4:17 pm
We solved.
I also found the OBD socket was right under my nose in the fuse box, covered with a lid with three spare fuses.
I enclose a picture on the net with the fuse.
Anyway I did not used to anything, my SBB failed to connect to the immo.
Weird thing TMS, I could not read it on the programmer, but I dropped the key programming.
I did strap between pins 4 and 13 of the TMS (TMS works with the board and he took off) to operate the electric motor.
Then I tried to undo the 3 screws on the back of the pump housing. I managed, in the words of Florin, but we adopted a quicker solution: I cut with Flex rear, I opened with the 2 allen screws 5 of the electronics of the pump, I cut the black wire of the electronics and electro and I connected to + contact (brown wire from the pump jack).
That's it!

[mariusbarcelona2010]

I have find this.....try it and tell us if it warks