How to read renault edc16 c3 and cp33?

[obnchip]

What flasher can read by obd renault edc16 c3 and cp33?

I have try edc16 c3 with mpps v5.ecu found but cant read.I have not tried yet cp33.Need info about it.

thanks!

[mislav88]

be aware that with colnes you have big chances to lose injector codes and then you will have to use renault can CLIP to reprogram them

[alfy]

What flasher can read by obd renault edc16 c3 and cp33?

I have try edc16 c3 with mpps v5.ecu found but cant read.I have not tried yet cp33.Need info about it.

thanks!

Magpro2 did without problems, it reads injector codes first and than write codes back.

[eduardo74]

try to push ecu id
then turn ignition off
then turn ignition on
and try to read
you will for sure lost injector codes, must use renault clip for coding

but in any case this method is not safe in any way!
use BDM for read this type of ecu!

[VRPerformance]

most of the original tools can read it,also can read injector codes

[eduardo74]

Yes m8!

Clone can read codes to and write it to file together with VIN.



most of the original tools can read it,also can read injector codes

[obnchip]

so mpps v5 can fix at writing injector codes?

[mislav88]

no, with mpps you will lose codes for sure. someone said that magpro2 clone writes codes ok but i heard in general that magpro2 clone has many other problems.

if you dont have can clip, only safe way for you is BDM.

[obnchip]

bosch kts can recode it?

[z786]

i have same problem

i have V12

it reads the codes out but file is incomplete

can any1 show a way to get good read?

thanks

[bazare]

use magpro2 genuine. It reads file + injectors and no problem after flashing.

[z786]

any ideas how to with mpps v12

[mislav88]

you can do it but after that you have to recode injectors.

also i think i read somewhere that after write you have to turn ignition off and wait for about half an hour, and then injector codes wont be lost, but dont remember for which tool was that.

[obnchip]

try to push ecu id
then turn ignition off
then turn ignition on
and try to read
you will for sure lost injector codes, must use renault clip for coding

but in any case this method is not safe in any way!
use BDM for read this type of ecu!

It was working with mpps v5!Even injector coding!Mpps writed nos.file at writing!Ecu edc16 cp33!

Thanks!

[magictuners]

kess v2 original work good

[masterb]

Did kess v2 also read and write the codes?

Sent from my HTC Pyramid using Tapatalk

[Music73]

I havent actually got a kess v2 but i have seen it done with one, It was on a 55 plate 1.9 dci Renault laguna.. software came up and suggested you save injector codes first and then you could write them back after flashing.

[chris_e36_328]

Kess2 safe on CP33. injector codes stay as before the read. tried and tested.

[koz]

CMD automatically reads and write injector codes, Byteshooter - you should do it manually. I had no issues with any of the two tools