psa edc15 1plug 88pin pinout and boot mode

[Foblas]

Hello,
i have 406 psa edc15c2 old type ecu with 1 plug 88pins on my car

while erasing-writing with galetto windows crashed and i cant write it again.

galetto detect ecu without any software numbers, but ecu response.

I cant find pinout for this ecu, only for 2 or 3 plug version.
How can a read it on table with boot mode?
unfortunately i have not adapter for am29f400 to desolder flash.

Is it possible to recover flash without desoldering?

[lupu_sandu]

AFAIK, for any EDC15 pin 24 from flash is boot pin.
Connect to GND and power ECU. Try to write.

[Foblas]

i know about 24pin
I try on the car - no effect.
want to try on table but i have no ecu pinout for 1 plug type ecu.

[Foblas]

should i write it as usually? ***1054;ust check in galetto for example Peugeot - edc15 am29F400BT - 406 2.0hdi ? I cant find any information about "boot mode" for psa edc15 in galetto.

[tinchocbr]

The boot mode it a toch for few second to gnd, but its only a bank. In the car i never prove this boot mode.
Without contac (+ ingnition) put gnd for this pin (image), put contac (+ ignition) a wait 3 or 4 second, and remove the pin boot on the ecu. The check engine in boot mode its off, if is on, the boot mode fail.
Other solution its reprogram 29f400 with programmer eeprom.
PD: Sorry for my ingles, its to basic.
http://youyoukiller.free.fr/boot_mode/Peugot_EDC15-C2.jpg

[btr]

should i write it as usually? ***1054;ust check in galetto for example Peugeot - edc15 am29F400BT - 406 2.0hdi ? I cant find any information about "boot mode" for psa edc15 in galetto.
Easy way:
desolder st95p08 eeprom,and you reflash am29f400bt without problem with galletto,or kwp2000(tested)
don't forget thanks button

[btr]

pin's for connection for the programming on the table,without car

[macxlulu]

use mpps recovery for edc15 work ok !

1)select the car and ecu
2) not click ecu id
3)use write file

tested to many blocked edc15