MAZDA 626 KEY LOST

[pe locksmiths]

Hi M8's,

Customer lost all his keys for mazda 626 2001 model.How can I program new key and do I need 1 or 2 keys. Where is the immo if I have to read it.

Thanks Andries

[Meat-Head]

Yo use the search botton - member Darwins did a Mazda Rice Burner have a squint

[elmaalouf]

which programer u have?

[pe locksmiths]

I've got T300, SBB & Zed-Bull.
My friend has AD100 & MVP
Will any one of these do the job

[JOHNCICY]

is it possible Immo off!

[pe locksmiths]

Don't know. Took the immo out and it is a lucas small black box with serial no 6948637449.
Need a pin code or pass code to program keys manually.
Thanks

[joubliss]

u have to read HCO5B6.

[pe locksmiths]

[QUOTE=joubliss;1415195]u have to read HCO5B6.[/QUOT

where will i find that. there is no such code inside the box.

[Automat]

T300 has serial number conversion-to-pin code.
Use manual code entry procedure.

ORIGINATE A NEW KEY/ADD A DUPLICATE KEY:
1. Insert a new key into ignition and turn it to ON. Turn back to the LOCK position. Repeat until this has been done five times. Do not leave the key in
any position for more than one second during this step.
2. Turn the key back to the ON position. The dashboard security light should be flashing rapidly. Within 20 seconds turn the key to the LOCK position
and leave it there for 5 minutes. After this 5 minute delay, the flashing security light will slow down.
3. Within twenty seconds, enter the password. (The password is obtained by supplying the vehicle Immobilizer Unit serial number to Mazda, or use T300 converter. This is converted to an 8 digit number unique to each Immobilizer Unit).
4. While watching the dashboard security light, turn the ignition to ON. Count the number of flashes and turn it back to LOCK when the number of
flashes equals the first digit of the password.
5. Within thirty seconds, turn the ignition back to ON. Count the number of flashes and turn it back to LOCK when the number of flashes equals the second
digit of the password.
6. Repeat until all eight codeword digits have been entered. Carefully turn the lock from one position to the other only when the security light is off.
If a mistake is made or you lose count of flashes, wait 45 seconds and start again at Step 1.
7. When the security light stops flashing and stays on,this indicates the password has been entered successfully.
8. Start the vehicle and the security light should go off within two seconds.
9. Removing the previous key, inserting the new key and starting the car within 20 seconds can add additional new keys.
10.Thirty seconds after the last key has been programmed, the vehicles programming cycle will end and return to the normal operating mode.

[cjawahir]

hello the pin is ......... 37516363

cj

[pe locksmiths]

hello the pin is ......... 37516363

cj

Will try this and let you know if I was succesfull.
Thanks :celtictop:

[camelgd]

Automat,
So the t300 does not have to be hooked in to OBD port to do calculation, did I understand correctly?
camelgd

[ray-ray]

What do you do if car does not go into programming mode,doesn't matter what you do?

[key]

What do you do if car does not go into programming mode,doesn't matter what you do?
If car does not go into programming mode,is not suitable transponder type.