Mazda 6 non start

[purdy]

I all thought I would share this. Ran us round for a bit with an interesting solution. Had a mazda 6 non start 2lt rf diesel. Codes reported for crank sensor. Only returned when toe start . But no codes reported on starter cranking. Car will run on easy start? No injector pulse. Good pump pressure. Good signal from crank sensor. Good signal front cam sensor. But no injector drive. Piloted the cam and crank together . Crank index 30* out from cam se?or. Compared this with a runner Mazda 6 which cam and crank indexes were together. Cam belt timing ok. Cam shaft Pulley to cam timed ok. Now scratching head! Cam index attached to PAS drive pulley on far end of cam shaft. Striped down and located sheared pin between pulley an cam shaft . 50 p fix. For new pin. Hope this helps someone.

[Meat-Head]

BMT - Bump My Thread with that please

http://www.digital-kaos.co.uk/forums/f152/tricks-tips-67505/

[Meat-Head]

POST CLOCKING:-

Did have a Nova in once, yes that's right, Nova, carbatooter, no spark, took very very little time to find the lump stick has craked into two parts, cylinder 1+2 were getting fuel/air, but no spark 3+4 - were just suck/blow.

[Ashraf6119]

I all thought I would share this. Ran us round for a bit with an interesting solution. Had a mazda 6 non start 2lt rf diesel. Codes reported for crank sensor. Only returned when toe start . But no codes reported on starter cranking. Car will run on easy start? No injector pulse. Good pump pressure. Good signal from crank sensor. Good signal front cam sensor. But no injector drive. Piloted the cam and crank together . Crank index 30* out from cam se?or. Compared this with a runner Mazda 6 which cam and crank indexes were together. Cam belt timing ok. Cam shaft Pulley to cam timed ok. Now scratching head! Cam index attached to PAS drive pulley on far end of cam shaft. Striped down and located sheared pin between pulley an cam shaft . 50 p fix. For new pin. Hope this helps someone.

It would be nice next time such fixes if you could take some picture and post on here.............I know its bit odd but it would be helpful..............

Anyway thanks for feed back..........good job mate........