VW Polo 2000year key matching problem

[mellon]

Polo 2000year, transponder 44

Immo Valeo 6X0 953 257. Eprom 24c04. PIN: 01497. In immo box in extra field I have VIN and Immo-ID XXXXXXXXXXXXXX. I can't program key. I tried SSB, Vag can plus 2.0 and oryginal VCDS. In immo there is 2 errors: signal key and programming key. UIn ecu is error: blocked ecu. I have one key. I checked the transponder and sends it. The coil is OK. Maybe immo box is broken?

Please help.
Adam

[baltazar3]

You should remove immo

[wd bau]

Did u use right key (id vag 44)?, leave the key with ignition on for half hour and try again.

[boukad]

hi
the code pin 1497
no default

[mellon]

hi
the code pin 1497
no default

I wrote that the pin is 01497! I have one original key. A friend went to the oil change and after replacing oil the car no works. Car start and off. It is 100% immo problem. Why I can't program key?

[mellon]

I think that is problem in immo box. I read ecu 95080. This is probably immo2 so in ecu no pin. Please check.

[flyins]

MM ecu you should check as i think no immo off, code read full car and see what faults your getting, you are probably right about broken immo box as have had them with water ingress, seems if you have ID and VIN you have immo 3, check the ross site for how to find out the difference,

[nasir]

IF YOU R USING THE RIGHT KEY ID THEN THE PROBLEM WITH YOUR IMM BOX OR ANTENNA COIL.

[danielboom00]

hi mates,

i have the same vw polo with the same ECU, and i want to immo off, i have read many post but i don?t know how to put immo off in the ecu.

thanks in advance