View Full Version : Dodge code p1697 after udjustment
labusas
25th January, 2012, 02:52 PM
Hi everyone,
Car is US Dodge Durango 05. Dash km was done OK.
Mileage is also stored in engine controller SRI.
I reset it with Lauch Master x431 - it had an option to change.
After it read mileage around 0 km.
but now:
code "p1697 PCM Failure SRI Mile Not Stored"
This probably is the result of a flash interruption - launch couldn't successfully write new km.
How to go about fixing this? I don't have flashing capabilities for chryslers.
Thanks
labusas
26th January, 2012, 12:07 AM
Ok, I'm looking to a cheapest solution to program Chrysler SRI (service Reminder information).
Is there a standalone OBD tool that does just that?
Thanks for you time
smalliron
26th January, 2012, 09:11 AM
Ok, I'm looking to a cheapest solution to program Chrysler SRI (service Reminder information).
Is there a standalone OBD tool that does just that?
Thanks for you time
I don't know the cheapest solution but if you have access to one of these you can do this job:
- AVDI Chrysler Commander
- DP3
- WiTech
bkenigma
26th January, 2012, 10:46 PM
Ok, I'm looking to a cheapest solution to program Chrysler SRI (service Reminder information).
Is there a standalone OBD tool that does just that?
Thanks for you time
Where are you located? You could always go with a Smok Chrysler tool to do the SRI which would cost few euros and let you be able to do all SRI systems in future
bkenigma
labusas
27th January, 2012, 04:46 AM
Thanks Frankie,
I've looked at smok but on their page it says still:
SRI 5 - coming soon
and that is what I need for this durango.
Unless they have it but not updated their page?
Speedosoft
27th January, 2012, 10:17 AM
Yes OEM tool: Starscan or Witech; or non OEM such as Jprog.
labusas
27th January, 2012, 02:48 PM
Thanks Speedosoft, I'd love a Jprog but it's pricey for just an SRI, not enough work here to buy another expensive tool.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.