terrys
28th January, 2012, 07:34 PM
Hi just tried to flashing ET9200 with the OpenPLi Beta image on USB stick, but on boot up the box did not see new image this seem to be because I had a USB hard drive plug in at the back of the box. Just to let all know and say thanks for the help
Terrys
billyboy2011
6th February, 2012, 11:15 PM
happens to all us newbies....hahah
The best way is to remove all usb devices, shut down the box.
Then turn it off at the rear.
Put the usb key containing the flash image of your choice (i like open pli) and turn on the button.
If you have the correct folders on the usb key, the display will say " found image"
Then just press the OK button on your remote....
and away you go *-)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.