Bmw F10 5 serie

[markony79]

Some pdf files for dash

[markony79]

and be carefull with 2 flat cables
the needles is need also to remove, but its not problem

its have 160D0WQ and near the 95320 eeprom
be carefull

[markony79]

Codyprog work perfect on this chips,
but the Cas4 is not posible with Can blocker
I was order the new Cas from dealer,
its cost 380e, and wait 3 days

the errors and service on this car,
Dp3 not work att all,
i was use the china DIAGUN, with new version, its work perfect

Regards to all on DK!!!!

[oep]

Tnx mark
Cas4? What's inside, mask?

[CARPARTS]

the first generation of F bodies with CAS4 have micro with 1L15Y /XDP512

xprog can read them

the latest have the 5M48H / XEP512

not yet possible to read

[CARPARTS]

Codyprog work perfect on this chips,
but the Cas4 is not posible with Can blocker

from which manufacturer was that c an blocker what not work ?
which maskset had the CAS ?
how much voltage you used to erase that 160D0WQ ?

thx

[elephantul]

in this dash take care with black cover in front, when remove needels dont scratch black surface , is very easy to damage irevocabli this, even litle dust destroit it

[smartymarti]

from which manufacturer was that c an blocker what not work ?
which maskset had the CAS ?
how much voltage you used to erase that 160D0WQ ?

thx


elprosys sell them and the voltage required will be 5v to erase the chip

[dataprog]

chip 160D0WQ

[Speedosoft]

the first generation of F bodies with CAS4 have micro with 1L15Y /XDP512

xprog can read them

the latest have the 5M48H / XEP512

not yet possible to read

That's correct but only in F01/F02 (7 series). All F10s came with 4M48H and like you said 5M48H (XEP768 and XEP100).

[Speedosoft]

Codyprog work perfect on this chips,
but the Cas4 is not posible with Can blocker
I was order the new Cas from dealer,
its cost 380e, and wait 3 days

the errors and service on this car,
Dp3 not work att all,
i was use the china DIAGUN, with new version, its work perfect

Regards to all on DK!!!!

Have you installed the new CAS4 yet? Or still waiting? If yes, can you confirm there was no alignment needed? It should come already programmed...to start your car.

[markony79]

Yes, its come allready programed,
start the ca r directly,

but oreder can do only owner for car with his ID card
its not like before in 2011 years, they change the rules

[markony79]

the black cover plastik with numbers for clocks under needles,
I allways put little paper and remove needles with knife,'
and the its not posible to scrach the color