XprogM

[vincent123]

Hi DK members
I tried to write a new flash to eis 211 HC12, but failed !

I select 912D128 flash>Open the new file> then write.
It go on....untill verifying by itself , then error on verifying.
If i choose NO, it stop at that! if i choose yes to ALL> nothing written at the end..still fffff...from 8000 onward.

my method correct ?

thanks

[vincent123]

this is the picture which show error

[starkey]

this is the picture which show error
hello friend, need R260

[gtmech]

check for dirty or bad connections, this is an easy chip to reprogram with XProg-m so if it reads ok but wont verify after write then you probably have dirty or bad connection. Will it erase ok?

[Zmann]

hi gtmech, because you use ori xrog where many ppl don't :)

[keygargoil]

turn off verify in the enviromenty menu and you will be ok some x prog clones have problems writing flash so use r270 or rosfar etc