corsa d

[madmanc]

2008 1.2 petrol corsa d , car not starting car with spanner light constanlty flashing,

someone has already had a go at this car , from what i know ,

one morning car no starting. then had key reprogrammed and still the same.

then diag done , in ecu faults where wrong identifier from bcm wrong key transponder.

it has had ecu reset and the reprogrammed,
then it has had bcm reset and reprogrammed.
now it has above faults and basically all immobiliser items have wrong identifier faults.

so where to start with this ?
any ideas or any one have a guide to fully reset the whole system?

thanks in advance.

ps i was thinking , reset bcm then rest ecu then reset clocks, then rest airbag ecu , then programme brand new key any thoughts? (is key a id46) chhers again

[mondis]

reprogram bsi with tech new software have in this year.problems is in software bsi in this year .i work opel

[Doru Lucian]

I thing your problem is in instumen panel,(dashbord)bad soldering.

[flyins]

Is your bcm,ecu etc all accept pin?? If so your good to go, DONT forget to code the sdm (airbag module) in as it looks in the system for the module, if its not programmed in the car WONT start and you still get car/spanner light, if your using op com you will need to disconnect battery count to ten slowly and re connect after youve pressed program in the sdm(with my op com i do anyway), leave the programming of the sdm till last, also MAKE SURE youve got a good battery or you might aswell forget it,
And mondis is correct, if you got tech 2 get update for bcm, these bcm are a waste of space and get corrupt so easy with low battery and spike

IRONJOE posted this on the subject too "This is a common problem with the corsa d,all you have to do is reset/reprogram bcm,dont reset ecu and bcm otherwise new keys required"

[willywonker2010]

update bcm and ecu
all will be good
my man at opel done mine
i spent 12 hours strait
bad software on bcu
bad battery crashes system

[willywonker2010]

use tech2 with pass throught
sps update
op-com will not update software
or find eeprom and virginise
in bcu
good luck cost me ?65 at uk vauxhall
with good friend who worked there

[madmanc]

well im all sorted now thanks for all the help and info, i thought id post how i sorted it theres nothing worse than searching and finding 99% of the time the solution never get posted.

1reset ipc
2 reset bcm
3 reprogramme original key
4 reset airbag module

5 turned off ignition for 30 seconds
6 programme the ipc
7 programme the bcm
8 programme the airbag module
9 read and clear all fault codes
10 ignition off 30 seconds
11 START CAR .

i did try for an houre very similar procdures all failed .

thanks again

[gennius]

Do you try to reprogram BCM.If you have Tech 2 you can try to reprogram BCM.

[madmanc]

no tech 2..... i used opcom

[willywonker2010]

lucky guy
i repair 1 corsa no problem
2nd one woudnt haveit
glad u sorted it

[gennius]

I do not know whether your opcom can programming BCM on your car but i know that Tech 2 can reprogramming BCM.

[Meat-Head]

BUMPING

SO is the battery ok on the car?
intresting hoe oe member siad you need new keys, but you didn't.

Meat

DAMM adding words for furture refence for searching

"corsa d" "flat battery" "flashing spanner" "reprogrammed"

[willywonker2010]

u not need new keys
keys all tied to vin and pin
if all reset but coorect vin
and pin all old keys work
cheers
bloody nightmare corsa d