View Full Version : can i off immo on this 1996 seat ecu
sideshow
17th February, 2012, 08:13 AM
hi all still trying to figure if this ecu can have immo off
here is ecu case and numbers
http://i953.photobucket.com/albums/ae19/sideshow10/seatengecu.jpg
here is board inside
http://i953.photobucket.com/albums/ae19/sideshow10/seatengineecu.jpg
here is immob unit ecu board
http://i953.photobucket.com/albums/ae19/sideshow10/seatimmob.jpg
dont know which chip to read
any help is greatly appreciated
AdamDavidSzocs
17th February, 2012, 08:35 AM
I hope this helps you.
ninja123
17th February, 2012, 09:04 AM
is this for immo off done from immo box or ecu?
ninja
baltazar3
17th February, 2012, 09:34 AM
Read HC05B6 and post here.Contact Lupu_sandu.He is master for that.
sideshow
17th February, 2012, 10:53 AM
hey baltazar where is that chip
i went over the photos and could not find chip with those details
i have a 3m clip that clips onto 8 pin chips but only one i find is on immob ecu
so if its another chip ill need an adapter or desolder
sideshow
17th February, 2012, 11:04 AM
hey adam the car is a seat cordoba with petrool motor
im not sure on motor as there is no info anywhere
guess i can find the engine number and go of that
would the ibiza file be the same
maybe i can do a compare once i read the orig dump
thanks
ammarben
17th February, 2012, 11:37 AM
read MC68HC05b (http://www.digital-kaos.co.uk/forums/attachments/f178/103770d1329464102-can-i-off-immo-1996-seat-ecu-seat-ibiza-5wk4-immo-dump-mc68hc05b16-immo-off.rar) mask 0F10V from immobox
sideshow
17th February, 2012, 12:12 PM
ok thanks
so the big 0f10v is the chip i need to read
ill see if i can get an adapter for my wellem
thanks
baltazar3
17th February, 2012, 01:45 PM
Willem cant read MCU-s.You need UPA or X-prog
sideshow
18th February, 2012, 02:16 AM
ok just looked for those programmers
looks like I need to desolder chip which
I didn't want to go that far
maybe I'll just charge him a lot and fit
new immob unit and program keys
just don't want to start damaging things
and then have to pay for them
thanks for your help
sideshow
18th February, 2012, 02:17 AM
I forgot to ask can i read it thru obd2 if I find a cable
baltazar3
18th February, 2012, 07:50 AM
You dont need to desolder MCU.With both tools you can read ICP,which mean that You have to solder some wires from programmer to MCU pins.It cant be done via OBD,
sideshow
18th February, 2012, 09:51 PM
Ok thanks I'll do some more researching
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.