what does this symbol mean? (piasini)

[Techhead]

This symbol is in a few of the pdf instructions for piasini, what does it relate to please?

[autotuning]

Its the connections on the tool to match to the connections on the ecu

[VTS_Tibi]

The big black dot on the right side is the place of the two ground wires, right?

The wire colours on the chinese clone does not match with those in the pdfs.

This is what in the instructions:

http://i1115.photobucket.com/albums/k545/TestorVTS/sym.jpg

And this is what mine looks like:

http://i1115.photobucket.com/albums/k545/TestorVTS/WP_000134.jpg

http://i1115.photobucket.com/albums/k545/TestorVTS/WP_000137.jpg


Does this mean that I've connected it the right way?

[VTS_Tibi]

bump - anyone?

[rocris]

bump - anyone?
Hi,
you need to coonect that cable like in picture from CD; on Cd where you have sw you also have 2 pictures.. you need to connect cables as in pictures not like in manual

[peregrine]

Ok from memory and it is not to shabby.

Red = positive 12V

Black = negative (ground)

Green = K line

Yellow = Flash voltage

Blue = boot pin

The other I have never used. You should have an external power source as you will need to connect this to the serial suite and then the red and black pins to the ecu.

The PDf instrucions are good just follow them. Let me know if you get stuck.

[peregrine]

The big black oval dot is for a conector on 4.3 version of Piasini, the 4.1 (clone is diffrent)