foufoucne
1st March, 2012, 11:42 PM
Hi
I have two C3 with the same problem
- the float is work
- the dashboard i think it's fine (i test it with PPS and i see the gauge full an empty )
I think the problem is the BSI
can any one help me to resolve this problem
thanks
radiosolutions
1st March, 2012, 11:52 PM
m8 if its the same as peugeot and i think it is, follow this procedure. unplug wiring from petrol pump under rear seat. find the 2 wires for the sender unit. place a 100 ohm resistor across 2 wires and put on the ignition, fuel should read about 3/4 of a tank. lock vehicle with remote and leave for 15 minutes without touching. then reopen vehicle remove resistor,plug back in wiring in pump. put ignition on, guage now calibrated. very common problem my friend,bsi looses config. hope this helps
dont forget to press thanks
foufoucne
2nd March, 2012, 12:28 AM
tomorrow i'll try this solution and i'll post the report
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.