BMW BOSCH ECU XPROG-M

[fear_dark]

Bosch ME9.2 how to read xprog-m
mpc555 connection?

[electrix]

It's typical Bosch EDC16 connection port. Use search button. It was explained many times.

[fear_dark]

It's typical Bosch EDC16 connection port. Use search button. It was explained many times.

This ECU is Bosch ME9.2.. There are 14 pins in EDC16 but ME9.2's 12..

[kareszka]

This ECU is Bosch ME9.2.. There are 14 pins in EDC16 but ME9.2's 12..
This is same ,see my photos : http://www.digital-kaos.co.uk/forums...9/#post1352051 (http://www.digital-kaos.co.uk/forums/f175/bmw-e46-engine-ecu-not-work-after-flash-whit-sss-241539/#post1352051)
Its so easy :beer:

[fear_dark]

where is the mistake?

[fear_dark]

xprog is waiting initialising device... where is the problem? is it xprog?

[jaelgti]

GOOD LUCK, THIS IS MY CONTRIBUTION

[kareszka]

This happen if mcu is dead or power supply ic (bosch 30460 or 30458) damaged.
I have ME9.2 ecu and I see where is 3.3v and 5v for mcu ,and I send photo.( you tested this without BDM adapter!!)

[fear_dark]

This happen if mcu is dead or power supply ic (bosch 30460 or 30458) damaged.
I have ME9.2 ecu and I see where is 3.3v and 5v for mcu ,and I send photo.( you tested this without BDM adapter!!)

I tried to read without connection. still xprog is waiting initilasing device screen. i thin

[fear_dark]

This happen if mcu is dead or power supply ic (bosch 30460 or 30458) damaged.
I have ME9.2 ecu and I see where is 3.3v and 5v for mcu ,and I send photo.( you tested this without BDM adapter!!)

I tried to read without connection. still xprog is waiting initilasing device screen. i think my xprog cant read mpc555

[MIKUr1]

Sorry for digging this thread but i have got same problem. Initialising all the time, and nothing else. Did you find out what was wrong?

[Lambda1]

5 sec in net you will find solution , search me9.2 bdm pinout