PDA

View Full Version : MPPS smart MEG1.0



dashboardkiller
11th March, 2012, 11:22 PM
Hi at all!

somebody know why the MPPS shows error when I try to write this ecu?

thanks!!

dk

deusbrest
12th March, 2012, 09:43 AM
Do you read/write in the boot mode?

dashboardkiller
12th March, 2012, 11:15 AM
hi,

no, I had an original, tuned it and try to write it.

should it be done by boot mode?

couldn`t I directly write by OBD?

thank you

regards

dk

deusbrest
12th March, 2012, 11:50 AM
i write smart only in boot mode
regards

dashboardkiller
12th March, 2012, 05:57 PM
i write smart only in boot mode
regards


thank you for the hint!

:)

donesko
12th March, 2012, 06:49 PM
if you succeed in boot mode please report.
I tried with two different ecu's no luck
http://www.digital-kaos.co.uk/forums/f173/boot-mode-question-239433/

Gizbern
12th March, 2012, 07:04 PM
I read boot mode, write normal

dashboardkiller
13th March, 2012, 11:00 AM
I read boot mode, write normal


I have the original, so I only needed to make the file and theoreticaly write it via OBD... but it shows a comunication error.

how can you read it in bootmode with MPPS ?

thanks to all!

regards

donesko
13th March, 2012, 11:46 AM
I have the original, so I only needed to make the file and theoreticaly write it via OBD... but it shows a comunication error.

how can you read it in bootmode with MPPS ?

thanks to all!

regards

put to gnd flash 24pin (eprom pin)
switch on power supply
up to gnd flash 24pin

donesko
13th March, 2012, 12:50 PM
question
wtf is this pin?
http://youyoukiller.free.fr/boot_mode/Pin%20Infos/SMART-MEG1.JPG

clio_williams
13th March, 2012, 02:15 PM
no need boot mode, just leave transmission in N position, then go ahead...

dashboardkiller
13th March, 2012, 09:06 PM
no need boot mode, just leave transmission in N position, then go ahead...


doesn?t run :(