Peugeot 407 Remote doesn't work

[amruss]

Hello...
I have got a problem with remote P407. I have got 2 of them, but no one work. When I diagnose by PP2000 I have not any problems. When I press 0 in 407 on cover back also doesn't work. Any idea friends what is wrong.
Regards...

[Ashraf6119]

Hi

1) Were they both working before.........?

2) Have you checked the Battery in the remote if its good.......... also the remote switches are working fine...............?

3) If they were both working before and the Battery is good than try re-synchronizing it again...........

4) Switch Ignition ON and press any button on remote for 30 sec..........

[locks85]

Hi, 407 car 2007 came to me and remote works only for 5 minutes after i resynchronise it to car, problem started when an electrician mdofied mileage, can i do something to fix this problem ?
regards
locks85

[genius76]

Procedure
1. Turn the Ignition switch to ON position using the first key.
2. Press the LOCK button for 10 seconds.
3. Remove key and wait for 10 seconds.
4. Check Plip key operation.
5. Repeat for second Plip key if required.
6. Turn ignition OFF

NOTE : If PLIPS still do not work, start the vehicle and then turn OFF.
Open and close the door, and check PLIP again. This is also necessary
after a new BSI system is fitted.

[genius76]

Also tray dealer methods :ciao:

Part 1
Lift Bonnet and prop up, open drivers window and leave open
Put Key in ignition and turn on ignition.
Turn off ignition and take key out whilst outside (through open drivers window)
Wait until mileage display goes out - Wait another 2 minutes
Disconnect positive on main battery (Bonnet is open!)
Wait 5 minutes
Re-connect main battery (Leave bonnet up)
Turn sidelights on then off from outside of car through drivers window that had been left open. Do not open door.

Part 2
Put key in ignition and turn ignition on, press lock button for 20 secs
Turn ignition off and remove key
Remote lock and remote alarm now work

[Azzx]

Recode the keys again with your PIN code, sometimes it's the only method to make the remote work again.