View Full Version : MPPS v12 on Saab 9-3?

31st March, 2012, 04:15 PM
Hi, i was working on a saab 9-3 2008 1.9tid

on the mpps soft it told me to completely remove key

when i did i couldnt access flash

but when i read it with ign. on it read fine

any ideas if i shud flash with key in ignition plz??


31st March, 2012, 04:18 PM
Always have ignition ON when reading or writing mate

31st March, 2012, 04:19 PM
why wud mpps say that then it doesnt make sense

31st March, 2012, 04:21 PM
Ive never seen mpps say that but i prefer to use v5 than v12

31st March, 2012, 04:25 PM
.....here :)

31st March, 2012, 04:28 PM
Just put ignition on mate and read or write it will be fine

31st March, 2012, 11:47 PM
I would ignore the message, read, and make sure you get a correct file. while reading no damage can be done.

If anything happens while writting you have the file at least.

so ignore the message

2nd April, 2012, 12:17 PM
remove key after writing then wait few seconds and put it back, if you dont do it like that you may get MIL but just clear it with diag and its ok.

5th July, 2012, 06:28 PM
Hi, did you read and write successfully with mpps?
You tunned this car ?

6th July, 2012, 12:28 AM
yes read perfect, wrote perfect

i got alexs307 to do 1 and ecutuners to do 1

9th July, 2012, 10:04 AM
Only use these files with MPPS as MPPS reads Opel EDC16 different to all other tools.

9th July, 2012, 10:29 AM
Please explain how it reads different? Thanks