View Full Version : MPPS v12 on Saab 9-3?
z786
31st March, 2012, 04:15 PM
Hi, i was working on a saab 9-3 2008 1.9tid
on the mpps soft it told me to completely remove key
when i did i couldnt access flash
but when i read it with ign. on it read fine
any ideas if i shud flash with key in ignition plz??
thanks
ecutuners
31st March, 2012, 04:18 PM
Always have ignition ON when reading or writing mate
z786
31st March, 2012, 04:19 PM
why wud mpps say that then it doesnt make sense
ecutuners
31st March, 2012, 04:21 PM
Ive never seen mpps say that but i prefer to use v5 than v12
z786
31st March, 2012, 04:25 PM
.....here :)
ecutuners
31st March, 2012, 04:28 PM
Just put ignition on mate and read or write it will be fine
ominimicu
31st March, 2012, 11:47 PM
I would ignore the message, read, and make sure you get a correct file. while reading no damage can be done.
If anything happens while writting you have the file at least.
so ignore the message
donesko
2nd April, 2012, 12:17 PM
remove key after writing then wait few seconds and put it back, if you dont do it like that you may get MIL but just clear it with diag and its ok.
darius89
5th July, 2012, 06:28 PM
Hi, did you read and write successfully with mpps?
You tunned this car ?
z786
6th July, 2012, 12:28 AM
yes read perfect, wrote perfect
i got alexs307 to do 1 and ecutuners to do 1
AyceeDeeCee
9th July, 2012, 10:04 AM
Only use these files with MPPS as MPPS reads Opel EDC16 different to all other tools.
wiseman
9th July, 2012, 10:29 AM
Please explain how it reads different? Thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.