PDA

View Full Version : Peugeot 206 1.6 hdi big turbo



acrilio
3rd April, 2012, 10:39 PM
hello, I have made ***8203;***8203;some adjustments in my car a few months ago I bought a bigger turbo a 1749, and was very lag. I have tried to increase the injection and assisted, closed geometry in the last two columns, of course increased the desired pressure for 2460, changed the limit and also the svbl. does someone can help me reduce the lag and more pressure? have now found two sites with omapas geometry turbo and in separate locations, which is what the car is normally use? the other is in limp mode?
attached ori mod and map pack.

gzk
4th April, 2012, 03:30 AM
chez your acuator need little adjustmeent

powertdi
4th April, 2012, 06:55 AM
Try this one with turbocontrol reduce. I dont see your original but you can try.

Stanton
4th April, 2012, 08:19 AM
It's most likely sized way off for your engine.

acrilio
4th April, 2012, 09:50 PM
Thanks for the replies. but 1E3050 also is not N75 map?
And if not too much to ask these maps are what?
16C920 ; 16CB60 ; 16CFEC. thanks

acrilio
5th April, 2012, 06:18 PM
did not notice any difference, can only be noted that the higher the temperature of the oil (the car has temp oil gauge), the better the car is
after testing the file, the car was the same, but when the oil temperature exceeded 90 degrees the car was a little better, the throttle response was better. is there any maps related to the temperature that is not to let the car go better?

acrilio
5th April, 2012, 07:57 PM
MAP sensor read more than 1.5 bar?