206 tacho 2000

[kams20040]

hi dear members I just try to program 206 years in 2000 with cable of TU (20) as usual but it does not even illuminate the TU is working when try my tacho on Clio but when I try in 206 absolutely nothing happened ,I connect my wire like the picture in manual but nothing someone have an idea ,it will be very appreciated.

[adam28]

You connect like this?

[kams20040]

You connect like this?
yes of course

[adam28]

Before i had similar problem, but it was some blown bulbs on the 206 cluster, which was why i had no illumination. When you plug cluster back into the car everything work ok?

[kams20040]

Before i had similar problem, but it was some blown bulbs on the 206 cluster, which was why i had no illumination. When you plug cluster back into the car everything work ok?
yes sir everything works ok ,it is not my first programation in 206 usually it work fine but today problem

[adam28]

Cant really think of anything else mate other checking simple things like the connection are good and that your TU is giving correct voltage etc.

Good luck

[kams20040]

i will verif thanks for your help

[Nofreeupdate]

this car have Jaeger and VDO version of dash
which is yours?

[kams20040]

this car have Jaeger and VDO version of dash
which is yours?
this is jaegger dash with two connector yellow and white

[PremierD]

lol lol lol this car have Jaeger and VDO version of dash
which is yours?

[kams20040]

lol lol lol this car have Jaeger and VDO version of dash
which is yours?this is a jaegger ,usually job done in 2 minutes easy job but today problem i dont know what is the problem

[PremierD]

I know it is mate .. I was laughing at NOfreeupdate .. coz it clearly states that it is a Jeager ..

[kams20040]

I know it is mate .. I was laughing at NOfreeupdate .. coz it clearly states that it is a Jeager ..
i understand ,

[Nofreeupdate]

this is jaegger dash with two connector yellow and white

use this then

have RX and Tx,
found on Tu cable 12v and put in like on photo

or try use Upa for this
its on Licznik , via dash conectors

I do this via diag on dash

[kams20040]

use this then
what connector for this program

[kams20040]

if i connect the cluster to the car and put only 2 wires ecr lec it work or not?

[Nofreeupdate]

maybe is good idea
but TU must have same power from car, maybe try on lighter and only 2 wires from cable,
but its more complicated

this HC05 processor, need minimum then 12v and more ampers then usualy charger