SCenic II dump P8200107954C x3 5.0C

[matias]

Hello all,
ahve anybody correctly dump to this dash?
Many thanks

[vuno01]

try this one

[matias]

Many thx. I try this and give report. I have problem with one dash. Dash works, but when I change dumps I can?t correctly check this. I have on VFD write Brake defect and I haven?t this take out.
Have any solution for this?
Many thx

[cotymoto]

see the picture m your dump. is correct all,

[matias]

OK, I try this today.

[matias]

Still the same. :-( I must find pinout from this dash, is possible if is problem in conector on the pin from brake.

[matias]

Many thx all for help. Dum was good. But on the pcb missed three resistors and one transistor. Maby was take off from hot air with make km in other people. :-) After I ake photo of this I upload this.