OPEL COMBO 2003 1.7 dtl problem pincode odometer

[tatop]

hi friends.
i have a problem with opel combo 1.7 year 2003
i use OPCOM2010
I had to replace engine control unit and pump ...
but now I have a problem
when I configure everything OPCOM, the engine ECU accepts code, the bcm ok, but not the odometer, it gives me an error (I reset it with OPCOM and since then I like to LOGIN "ffff") and I can encode it again
how can I do??

[knok]

hi friends.
i have a problem with opel combo 1.7 year 2003
i use OPCOM2010
I had to replace engine control unit and pump ...
but now I have a problem
when I configure everything OPCOM, the engine ECU accepts code, the bcm ok, but not the odometer, it gives me an error (I reset it with OPCOM and since then I like to LOGIN "ffff") and I can encode it again
how can I do??
leave ignition ON for a while , then off and try again ..
If not , repeat entire procedure for all modules which have stored security code.

[i_shot_the_sheriff]

I had the same problem.....
The fault was my chinese op-com!

Although there is a certain procedure that enables the reset of the opel dashboards out of the car that i wanna learn!
Does anyone knows how this is done?

[tatop]

opel comb0 2003 1.7 dtl
i reset bcm and dashboard with op com
i programmed bcm OK for login but VIN numbrer error (show vin code non programmed :OPCOM will only accept 8 characters and shows how to VIN 36007266. vin correct is WOLOXCF0633027266! ! why?
The dashboard does not accept more than the original login (me error) shows how to LOGIN "FFFF"
help me and from a week that there slam
thanks