View Full Version : BDM Magneti Marelli MJD 602
spawns3
24th April, 2012, 06:23 PM
Anyone know if with BDM 100 have to supply external power to this ecu ?
Cheers
ecutuners
24th April, 2012, 07:33 PM
Power it by the pins of ecu plug, its best way and you may need to remove a 0ohm resister to read and write by BDM
spawns3
26th April, 2012, 11:17 AM
I try to read by BDM but no success.The bdm port are damage, i have receive the ecu like that , but the car works . i connect 6 wires to try with bdm .
Anyone know if it's possible to flash the ecu by obd ? I try with galletto to read ecu ID and get -----0000.so I think the ecu is not dead. I don't have the car or diag tool with me to test it. The Mpps can write this ecu ?
The ecu is a
Magneti Marelli
MJD 6O2.A6/HW03F
71600.094.02
From Astra H 1.3CDTI 2006
Here a pic of BDM ports.
VRPerformance
26th April, 2012, 05:34 PM
yes it is possible :)
spawns3
26th April, 2012, 08:57 PM
yes it is possible :)
With Mpps ?
VRPerformance
26th April, 2012, 09:01 PM
dont know for MPPS i not use it,if you ask only for it sorry for bad answer,but with other tools is possible
powertdi
26th April, 2012, 09:33 PM
Galleto do it thru OBD by Can. If you remove 0resiostor you can read it with MPPS on bench by K-line
.tested:goodpost:
spawns3
26th April, 2012, 10:02 PM
I have tried in bench with mpps and galletto 1250 without sucess , but i don't remember if when i try with mpps i have the resistor in place or not : | for next week i try again.
But thanks anyway
Anmed
27th April, 2012, 03:22 PM
Poor, poor BDM-port, someone brutally tortured ...
spawns3
27th April, 2012, 05:21 PM
Poor, poor BDM-port, someone brutally tortured ...
I think the guy try with this
:wink:
pillsburry
27th November, 2018, 03:56 PM
hi have you tryed the other pin points on the tracks mate i now its a pain but worth a try mate
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.