View Full Version : W203 repair EIS, after replace MCU, not work
sss123456
4th May, 2012, 04:04 PM
Hi,
EIS 203 545 01 08
MCU : 4J74Y(196671) and 2J74Y(196670)
i read, copy and replace both MCU with 2J74Y but eis still dont work.
Can you please check my dump ?
Attach Mcu1 and Mcu2 full eeprom+flash.
Thank you !
JOHNCICY
4th May, 2012, 05:12 PM
TEST THS MATE WORKING 100%
sss123456
4th May, 2012, 05:14 PM
can i use your flash and use my eeprom ? does this works ?
JOHNCICY
4th May, 2012, 05:41 PM
can i use your flash and use my eeprom ? does this works ?
Yes it works
sss123456
5th May, 2012, 01:27 AM
man , have you ever tried it on EIS with 2x1J35D?
uchtool
5th May, 2012, 08:25 AM
can i use your flash and use my eeprom ? does this works ?
hi have u even readed the programmed flash and compare with the original flash dump?
which programmer tool did u used?
etl is the best for that :)
sss123456
5th May, 2012, 08:27 AM
yeah i use original ETL.
the EEPROM read is good.
I just worry about the flash part.
sss123456
6th May, 2012, 07:50 AM
wrong post.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.