View Full Version : Volvo S80
Sarkan
10th May, 2012, 05:56 PM
Is it possible to test the dashboard of volvo s80 2003year without BCM.I was conect pin 1 on +12V and pin 14 on -12V and nothing happens.
luiggii79
10th May, 2012, 06:06 PM
Is it possible to test the dashboard of volvo s80 2003year without BCM.I was conect pin 1 on +12V and pin 14 on -12V and nothing happens.
don't posible ,the volvo not use ignition positive pin .
the ignition command in the canbus line
what is the problem for that dashboard?
Sarkan
10th May, 2012, 08:46 PM
panel was completely dead.I was solder processor and now when i connect to +12V on middle two display show numbers but without background light.
binken
10th May, 2012, 10:33 PM
panel was completely dead.I was solder processor and now when i connect to +12V on middle two display show numbers but without background light.
change the small lamps behinds display , then it works fine !!
luiggii79
10th May, 2012, 10:39 PM
panel was completely dead.I was solder processor and now when i connect to +12V on middle two display show numbers but without background light.
post me photos if the posible
you dashbord is same for my photo?
Sarkan
10th May, 2012, 11:10 PM
post me photos if the posible
you dashbord is same for my photo?
Yes it it is same.
photographed with a mobile phone.photo is bad quality.You might see something.I note that the panel on the table and is not connected to the car.connected to only two wires for power
luiggii79
10th May, 2012, 11:37 PM
Yes it it is same.
photographed with a mobile phone.photo is bad quality.You might see something.I note that the panel on the table and is not connected to the car.connected to only two wires for power
this error location test and send report
resolder the all marked point
Sarkan
11th May, 2012, 12:01 AM
I already did that.After that I got these figures.before did not show anything.Car is not here,can not try on the car.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.