help toyota hilux key to dump

[elmaalouf]

hello friends pls i need help to insert the key data for hilux 2004 4d67 key
key data: B2 95 19D08416
Thanks in advance

[bram380]

Hi mate...read again the immo box 89780-xxxxx,
above dump not completed,
so it can not detect by all key programmer.

[elmaalouf]

Hello I tried to do it by car prog but it didn't work so may it wasn't completely connected so I think my dump is corrected can we use another dump and write inside the immo box. Does it can work? my immo box is 89780-35070 l thanks

[ajayrao]

hi
check now dump attached recognised by tango
regards

[elmaalouf]

hello friend did u inserted my key data inside?

[elmaalouf]

cuz i find on the forum this dump for the same car

[elmaalouf]

also friend Bram380 i finded a file i readed it first time i saw there is a small difference can u check it pls its attached here thanks a lot

[ajayrao]

hi
this dump with ur key inserted if not work try dump swap
regards

[ajayrao]

sorry dump

[bram380]

here dump with key B2 95 xxxxxx:
hilux_89780-35070 (https://www.rapidshare.com/files/2487864093/hilux_2004-2005_89780-35070_93c66_new_2012-05-11.rar)

[Arnold42]

ajayrao - your dump for 4C key. It's not correct.

[ajayrao]

@arnold 42 i used his dump and swap bytes and modify 2 bytes,and tango recognise his as 4d dump,
pls check attachment
best regards

[Arnold42]

Yes! So sorry, my mistake.

[elmaalouf]

thanks friend but it didnt work also the diagnostic isnt able to read the immo box when i put this dump

[keygargoil]

thanks friend but it didnt work also the diagnostic isnt able to read the immo box when i put this dump

here is your key added and your file is sorted

[keygargoil]

by the way you have read it in 8 bit not 16 so be carefull how you write it back

[elmaalouf]

hello friends i am trying to syncronyise the ecu with the immo box by the bridge btw pin 4 and 13 for the obd socket but it didnt work so any body can do my ecu file virgin may i will be able to syncronize? or anybody have ecu file withe immo box file so i will inser tthe key data
thanks

[keygargoil]

hello friends i am trying to syncronyise the ecu with the immo box by the bridge btw pin 4 and 13 for the obd socket but it didnt work so any body can do my ecu file virgin may i will be able to syncronize? or anybody have ecu file withe immo box file so i will inser tthe key data
thanks

your key is in the file the immo light is out yes, the car should be fine i do these all the time check the little resistor by the left side of the chip if it isnt making contact or is missing that may be your problem

also have you checked the data stream for your immo box cos you may of wrote it wrong

[keygargoil]

i have been looking at your key data and it isnt right this is a file i have made for you there is a bin file with the key data to write a tpx2 your key data can only start with 32 52 or92 for these early 4d files they are very funny about key position and page value

[elmaalouf]

so what i have to do ? i have to write it on tpx2? the 4d can't work ?