View Full Version : update xprog
kar407
13th May, 2012, 01:22 AM
hi every body
i have xprog from china, i always use the software version 4.5
there are any problem or risk if i change to version 5.0.
thinks
pawelelectro
13th May, 2012, 05:32 AM
There is no problem.
Zmann
13th May, 2012, 09:09 AM
With a bonus of countdown counter on each use.
gejzaslapka
13th May, 2012, 12:25 PM
where to check this counter? i am using V5 with chinese xprog and i never did not found a counter.
GS
Zmann
13th May, 2012, 12:55 PM
Counter is in the firmware and not visible unless reading it out by another programmer (if you can read).
gejzaslapka
13th May, 2012, 01:14 PM
does it some influence to something or it is a counter only?
Zmann
13th May, 2012, 01:38 PM
After the counter reachs zero read/verify will be no more consistent especially to most of the mcu's.
gejzaslapka
13th May, 2012, 02:25 PM
and what is the initial value? can it be simply reprogrammed? is it in some eeprom or in atmel inside?
GS
stefaudio
13th May, 2012, 03:09 PM
ic in atmega64
acoriano
17th May, 2012, 11:22 PM
where can I clear this counter ?
I have a XPROG not yet blocked
pawelelectro
22nd May, 2012, 10:14 AM
You must flash atmega.
barry94
22nd May, 2012, 12:59 PM
hi
if we flash atmega we lost all autorization we hare finish must
have .bin of atmega with all autorization
or
buy new xprog not another way...
have the file .bin to help to resoved...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.