View Full Version : need bdm > edc16u31 ecu schematic.
k0mpresd
16th May, 2012, 11:18 PM
need bdm > ecu schematic for edc16-u31 vag ecu.
this is bdm schematic:
http://i795.photobucket.com/albums/yy231/k0mpresd/edc16_jtag.png
is it 1:1 pin match up for bdm cable? ex: pin 1 > pin 1, pin 2 > pin 2, ect?
jaelgti
17th May, 2012, 10:44 AM
I think that you can use.
xtreem
17th May, 2012, 11:07 AM
hello
please post the schematic. if you can not see well
is the same for edc16c34?
jaelgti
17th May, 2012, 11:13 AM
hello
please post the schematic. if you can not see well
is the same for edc16c34?
You have the pdf BDM
jaelgti
17th May, 2012, 11:18 AM
PDF manual see you.
xtreem
17th May, 2012, 11:21 AM
my bdm is clone.
the scheme is equal?
jaelgti
17th May, 2012, 11:22 AM
my bdm is clone.
the scheme is equal?
SI.
Saludos.
k0mpresd
17th May, 2012, 05:57 PM
I think that you can use.
i did this and it worked but was told its not the proper way.
was told this is proper way:
http://i43.servimg.com/u/f43/16/03/79/30/edc1610.jpg
AGS
17th May, 2012, 08:39 PM
I think that you can use.
lot of work solder, buy wires springs bdm! the perfect solution,everything looks nice!
k0mpresd
17th May, 2012, 09:33 PM
lot of work solder, buy wires springs bdm! the perfect solution,everything looks nice!
i can solder a pin header in about 30 seconds. desolder in same amount of time and clean up the board using solder wick. seems easier than building a jig and adapter.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.