EZS 211_ST12 reading by xprog_m

[bangreno]

Please can somebody confirm if I can Read EZS from W203.
On board is written W211_ST12

[MarkPRP]

yes

connect as rosfar diagram, and then select 9s12 secured eeprom

mark

[Shmortz]

here is everything you need, read carrefuly...
if you get 'verify error' after reading click NO and read again, otherwise MCU flash can be deleted...

[16eddi67]

Please can somebody confirm if I can Read EZS from W203.
On board is written W211_ST12

Hi ,
Xprog-M MB211

[bangreno]

100% clear as diagram.
Managed to read 9St2, please can you check if dump is ok and calculate some keys .
I could not got original Coax or Twisted pair, so I built one with WIFI antena cable.
I didn't use XCLKS.
My doubt is about Reset pin not same in above diagram , and some resistors was to be remove in the second diagram.

[smayer]

100% clear as diagram.
Managed to read 9St2, please can you check if dump is ok and calculate some keys .
I could not got original Coax or Twisted pair, so I built one with WIFI antena cable.
I didn't use XCLKS.
My doubt is about Reset pin not same in above diagram , and some resistors was to be remove in the second diagram.

your dump is OK
WDB2030071F48xxxx
356556,8Km
Keys used 0,1,2,3 and 4

[bangreno]

Good news ,
Please Can you calculate one key for me.
Big thanks.

[bangreno]

Still in need of keys.
Thanks

[smayer]

Still in need of keys.
Thanks

Your keys mate

Best Regards

[agabna]

Please can somebody confirm if I can Read EZS from W203.
On board is written W211_ST12

yes it is the best way for 203 our 211 ezs 912
i used many times with xprog and you can do your own cable for upa also