EWS 4.3 with TM-prog or R260 ???

[Eskerra]

Hi, good evening.
I have one of this units EWS 4.3.
processor on it its a MC9S12D64.
Have someone please diagram or picture on how to connect mcu to any of both programmers???
Is this mcu secured, or not ?? How can know which mcu its secured and which are not ??
When open R260 software, how would be the options to check??

Thanks if someone can help me on this.
Regards.

[gadroulll]

IF YOU have original rosfar and ne software upadte of it ,you can do it .
i would suggest for safety to sesolder it and use etl programmer.

last time i do it with original rosfar and it cracked it

[Eskerra]

@gadroulll, thanks for answer.
My rosfar, is not original, is Red clone Rosfar.
Is it not safe to read with either these two programmers ( X-Prog or Red clone Rosfar) ???

Anyway I can firstly make a read, as a back-up, or even just trying to read, there is the chance that it gets corrupted or erased ???

Thanks.

[dontzapit]

Yes its secured chip and chance of corruption or erasure with clones is always very high



@gadroulll, thanks for answer.
My rosfar, is not original, is Red clone Rosfar.
Is it not safe to read with either these two programmers ( X-Prog or Red clone Rosfar) ???

Anyway I can firstly make a read, as a back-up, or even just trying to read, there is the chance that it gets corrupted or erased ???

Thanks.

[Fec001]

Can't read with Red R260 clone. Tried with R270 worked perfect!!!!