Immo off for Ford Fiesta 1999 - 25040

[ghkarim]

Hello,

Costomer have original key, Red lamp still ON.
He prefer to turn immo off to forget this problem for ever.

Thank you,

[dichar]

reference ecu is bosch ME7.1 ??

[jairpg21]

can you send a picture of pcb?

[ghkarim]

reference ecu is bosch ME7.1 ??

don't know if it's bosch , no label on ECU exept stiker that I joined.

regards

[ghkarim]

can you send a picture of pcb?

picture joined

[jairpg21]

Try removing this memory, in some ford you can immo off just doing this, please report

[ghkarim]

Try removing this memory, in some ford you can immo off just doing this, please report


will try and report

regards

[ghkarim]

removed mcu but didn't work.
>Thank you for advice,
Still waiting for other solution -))

[Dane-Elec]

removed mcu but didn't work.
>Thank you for advice,
Still waiting for other solution -))
Make a new key,or try to sincronyse again ecu, dash and key, as i know is not possible to make immo off on that type of ecu.

Dane

[keygargoil]

is the light on solid when the ignition is on or flashing if it is on solid then either the pats needs initialising or if it has been reset 3 keys need cycling in

[micromax]

if you have (ti) texas instruments mcu in plcc try this, work on many variants of EEC-V

[ghkarim]

Make a new key,or try to sincronyse again ecu, dash and key, as i know is not possible to make immo off on that type of ecu.

Dane


With wich tool can I resynchronize ECU? Or is there any manual procedure ?

regards

[ghkarim]

is the light on solid when the ignition is on or flashing if it is on solid then either the pats needs initialising or if it has been reset 3 keys need cycling in


The light still solid ON when I turn ignition ON.
Can't get comms with tester to reprogram keys.
regards

[ghkarim]

if you have (ti) texas instruments mcu in plcc try this, work on many variants of EEC-V


haven't TMS mcu in ECU. :-((

[Dane-Elec]

The light still solid ON when I turn ignition ON.
Can't get comms with tester to reprogram keys.
regards
Hi

Use IDS.

Dane

[micromax]

sbb can programm key. what is this IC?

[ghkarim]

sbb can programm key. what is this IC?


Sbb connect but can't get security access.
Number of key in memory = 0
after read DLC =
ERR9213 :
Key programmed less then minimum required.

Tried to reprogram new keywith SBB but can't get security access after 800s.

regards

[yssf]

For ford You'll need outcode to incode to get access to program key.
Find another tool m8,for this fault u can reprogram key and job done

[ruscic]

hello,
is there any solution for this ecu? i have shay eec-v ecu, VS&F-12A650-AKB.