Clio II uch BG need dump and code

[Amine13]

HI, here I have a clio II 1.4 16V, with flashing immo light on dash, tried to program key, but no way.
wires between coil and UCH are good,
when loaded the file, has VIN like 0123456789ABCDEF; get code, but still same...
If someone has a good dump for this UCH with the pin code, That will be awesome !!!
This clio Has central locking with remote, two electrical windows in front, Manual AC.
UCH ref is : UCH-BG P8200065817--A

Thanks in advance !!

[albertros]

Hi,
you risk altering the space - time continume by altering the dump.

If you have clip you can check if the key is being read and acepted.

If you have something like zedbull check theoriginal key is readable.

Flashing light indicates the uch to ecu comunications is not correct.

More info - what is the fault? none starter or just need another key?

Thanks

[Amine13]

Hi ,
I have scanned, and got two faults codes permanent,
Link from Decoder to coil (open or short)
Link from coil to decoder
regarding the visu and NT, wiring is good, in parameters, key stored 2, and the actual key in ignition is not recognized.
I have no zedbull or similar to check key, but I've got some similar cases where the UCH was faulty.

[igorr]

Tray to resolder coil in key,in most situation problem is coil in key

[albertros]

Hi,
the faults you list are :- Ring decoder and decoder ring fault. The car will sometimes not start until these faults are cleared.

They are not important initialy.

Unplug the white plugin the UCH for a min or so and then plug back.

Then try again.

fault could be the key but you need to clear listed faults in uch first