clio 2006 sim32

[redash]

hi there friends, i would like to try to clear immo off clio 2006 1.2 with the ecu:
s120200105a
8200522357
8200510536
sim32
i have checked some post relative to this thread, but i think they are not conclusive, some have file of immo off with pass, but no one says if really work, and if this is possible to clear from ecu dont you have to progam UCH or cut some wire???....any ideas files to test...do you want me to read eprrom on ecu???ideas???thanks in advance:coffin:

[helmi reguig]

immo off sim 32 100/100 ok pass pm
____________________________________
:vroam:
_______
_____

[albertros]

Hi,
please report back how you go on.

Itsmy understanding that the eprom is re-written by cpu so you haveto reprog both eeprom and cpu.
Thanks

[redash]

ok i have write file on eprrom of ecu using griffo progammer, but it didnt work, still have immo light on dash blinking, and car dont work....ideas????in attachament orig file ecu 95160
....do i need to cut some wire???

[mishu_b]

...
yes you need to cut Immo line otherways the uC will write back the immo info into flash!!!

I do not have access now to Autodata, but you can check there the immo line!

br

[albertros]

Hi,
I have seen these dumps on here before and they have yet to work.

The internal upc writes to the eeprom, no amoumt of cutting immo wires will stop that.

It is pos to decode but you need one of the expencive reprogramers, I forget which one,

Try listing the problem. start from there.

[redash]

ok...so from the immo ring to uch goes 3 wires
yellow-alimentation
black- ground
bronw- i cut this one (pin 38 on uch)
still no work, i also have tested another file in forum and nothing........by my logic when i turn on key the immo ring receives a signal from key, that sends to UCH, and then it comunicates with ECU....right???so dont i need to read eproom on UCH and change it.....??????

[albertros]

Hi,
if you have clip you can see if the uch has read the key and second that the number it has read is accepted.

Trust me unless you have some fancy kit you are heading no where with an immo of.

As I said start by explaining what the flashing led is doing and does the engine crank.

Its always better to fix the fault. Relays / fuses / ground wires and loom faults areall possible on this one.

[WISETIGER]

Hello
immo on CAN sim 32 i stored in flash 64F7055
hERE is vigin flash with no password
press thx please365857

[dadal]

Hello
immo on CAN sim 32 i stored in flash 64F7055
hERE is vigin flash with no password
press thx please365857
I've heard that immo in mcu 64f7055 and eprom ,,do you have eprom file too ?
thanks

[dadal]

Hello
immo on CAN sim 32 i stored in flash 64F7055
hERE is vigin flash with no password
press thx please365857


Hi Mate I hava an ecu megane sagem s3000 ( Flash 6F7055 )
i can read this ecu full flash by galetto v54 but I cant Write it back to ecu .. I have used diagram of galetto
do you have some trick for me to write this ecu ?