View Full Version : Problem with codi prog
tmohabir
6th July, 2012, 06:45 PM
Hi guys I am trying to do a 07 bmw m5 cluster using dashfixer pro and dp2/elpros , neither one is able to write the new # I tried to erase using codiprog but I dont have any communication with the cluster
obdmaster
6th July, 2012, 06:58 PM
Hi guys I am trying to do a 07 bmw m5 cluster using dashfixer pro and dp2/elpros , neither one is able to write the new # I tried to erase using codiprog but I dont have any communication with the cluster
try new chip m8, instead of erasing
just hope your original read was good m8, as now original dump is gone for good.
markony79
6th July, 2012, 10:25 PM
Hi guys I am trying to do a 07 bmw m5 cluster using dashfixer pro and dp2/elpros , neither one is able to write the new # I tried to erase using codiprog but I dont have any communication with the cluster
you have Codyprog, OK
the do like this
clean the legs from chip,no need to remove from board
then Read and Save dump
then must use Codyprog (stand alone) for errasing
it this year must be 080D0WQ,
then OFF jumper Nr2, and press the button on Codyprog,
need 10 sec to errased this chip
then Read again, and you will see first 2 lines its 0000
then you can write the new KM
ALEXEI
6th July, 2012, 10:30 PM
you have Codyprog, OK
the do like this
clean the legs from chip,no need to remove from board
then Read and Save dump
then must use Codyprog (stand alone) for errasing
it this year must be 080D0WQ,
then OFF jumper Nr2, and press the button on Codyprog,
need 10 sec to errased this chip
then Read again, and you will see first 2 lines its 0000
then you can write the new KM
youre right markony. this tool work for me only for D80 eeproms. dont know why it dosent erase also vp eeproms. Ive been changed all buffers from pcb
tmohabir
7th July, 2012, 11:58 PM
Thanks works like a charm. Thanks again
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.