PDA

View Full Version : PROGRAMMING A NEW ECU FORD


elmassioui
6th July, 2012, 07:59 PM
HI ALL
which tool can PROGRAMMING NEW ECU FOR FORD TRANSIT 2007.
THANK YOU.
eeddyy23
9th July, 2012, 06:27 AM
HI ALL
which tool can PROGRAMMING NEW ECU FOR FORD TRANSIT 2007.
THANK YOU.
the only one that can do it ids with calibrations
leandroks
9th July, 2012, 02:05 PM
Yes that is right Vcm ids, but u have to buy a good one otherwise forget it..
autotuning
9th July, 2012, 02:14 PM
And you also need access to the ford incodes or you wont even get started, if you have never done this before i advise you find someone with the IDS and incode calculator that will allow you to learn from them for the 1st time, there are codes needed to select the correct calibrations some are on the van and some you need the as built data for from Ford
Regards
Dave
Dunker
13th July, 2012, 10:13 AM
Depending on the PCB number the Transit ECUs are easy enough to clone. MCU (axle ratio plus lots of other stuff in the MCU) and eeprom both need to be copied.
furburger
24th July, 2012, 12:45 PM
Can you help me identify the EEPROM that holds some data ? I am interested in cloning these Ecu and in this moment can only read the Irom with my Bs in boot mode
mastaflex
1st August, 2012, 01:40 AM
better to use IDS, and get an incode access
furburger
2nd August, 2012, 09:34 AM
Depending on the PCB number the Transit ECUs are easy enough to clone. MCU (axle ratio plus lots of other stuff in the MCU) and eeprom both need to be copied.


Can you give an example of a pcb number that can be cloned?
Dunker
2nd August, 2012, 05:52 PM
DPC806, stuff like that.
didi_du_93000
22nd December, 2012, 11:27 PM
Use the bestool for make it...

http://www.nasratech.com/

tool for FORD FIAT OPEL.

Very good tool.