PDF for KAWASAKI - Piasini Serial Suite

[djbiugi]

Hi

no find instruction about ecu Denso kawasaki Z1000 '06 - '09 and Kawasaki Bikes in generan

Anybody can upload this please? thanks :-)

[djbiugi]

I see in Serial Suite that is possible with serial protocol :-) see this PDF with pinout from manual about Z1000

PIN 17 = +12v
PIn 34 = GND

Then,i don't know the other pin to connect Serial Suite

[djbiugi]

Nobody can help me about?

[rsibiza]

Hi

no find instruction about ecu Denso kawasaki Z1000 '06 - '09 and Kawasaki Bikes in generan

Anybody can upload this please? thanks :-)


I have same problem.
I looked around,and saw Yamaha Fazer 600 uses also Mitsubishi ECU,and there is only connect K line Flash Voltage VCC and gnd,no boot needet...

I think i will try it...I have one frenche ECU 107 hp and one Full 175 hp ECU....lets see if its possible swap french 107 hp ecu to full 175 hp one ;)

BR.RS

[ducatisti]

Hi

no find instruction about ecu Denso kawasaki Z1000 '06 - '09 and Kawasaki Bikes in generan

Anybody can upload this please? thanks :-)

If this denso has a 32r inside it can read write by the plug but it will not be k line

If it has denso 7052 inside you open the ecu to read it and flash it by tx / rx / reset.

I havent seen this ecu yet. Maybe post a picture

[rsibiza]

The 2011-2012 MY seems being different,have 3 rows of 13 pins for each connector :(

So we start ower again ;) an search for documents about...

Best regards.RS

[ducatisti]

If its a denso ecu you need to open it and read it with the 10 wires from flat cable. To write ecu you find tx/rx FWE. You can find by scraping the board because they are labled or guessing.

[rsibiza]

On outside the ecu have a Mitsubishi label, and PCB is lully glued by black silicone (PUR) interior - EXT (PBT) is written on it.

An have these numbers 21175-0327
F8TG0372 OY15

tomorrow i will post an pic of it ;)

Thx. And best regards.RS

[ducatisti]

I have same problem.
I looked around,and saw Yamaha Fazer 600 uses also Mitsubishi ECU,and there is only connect K line Flash Voltage VCC and gnd,no boot needet...

I think i will try it...I have one frenche ECU 107 hp and one Full 175 hp ECU....lets see if its possible swap french 107 hp ecu to full 175 hp one ;)

BR.RS

the ecu will not take the file . the maps need to be changed

[djbiugi]

Hi...any news about PDF Kawasaki connection?