OVERSPEED
31st July, 2012, 03:39 PM
Maybe helps someone
My MP start one day to show "magpro no found" error, I tried everything, reinstal software, reinstal FTD... It begins to show MAGPROerror#100 or Flashtecerror#01 and I noticed the red led was on instead of blinking and the software didin?t start anymore (just hanged). tried several times and it always hanged in start.
If I disconect the device, and reconect the red led blinking faster than its normal, when start the program the red led becomes on all the time and the program hanged
I open the case, and tried to start the software again, but touching the pins at the 29F200 one time the red led start blinking again and it worked again.
now it?s normal again !
So if someone have similar problem you can try these.
perhaps this "touch" grounded some pin and start bootmode to alow the device to be reprogramed or was pure luck ?
[ sorry if there is some error, i?m brazilian and english is not my strong side]
My MP start one day to show "magpro no found" error, I tried everything, reinstal software, reinstal FTD... It begins to show MAGPROerror#100 or Flashtecerror#01 and I noticed the red led was on instead of blinking and the software didin?t start anymore (just hanged). tried several times and it always hanged in start.
If I disconect the device, and reconect the red led blinking faster than its normal, when start the program the red led becomes on all the time and the program hanged
I open the case, and tried to start the software again, but touching the pins at the 29F200 one time the red led start blinking again and it worked again.
now it?s normal again !
So if someone have similar problem you can try these.
perhaps this "touch" grounded some pin and start bootmode to alow the device to be reprogramed or was pure luck ?
[ sorry if there is some error, i?m brazilian and english is not my strong side]