Dreamer
11th May, 2008, 11:46 AM
I have installed 2x512mb sdram with ecc, onto my friends computer and it is not reporting the correct amount. It's only reporting 500 odd mb in total
The mother board is a 993AS it has 3 Dimm slots and according to the motherboard manual it supports up to 3x168pin sdram modules with ecc pc133 and run at 133 or 150 mhz and the max capacity is 1.5GB
I've had a look in the bios and dont see anything that can be changed apart from the Ecc enable or disable.
memory was purchased from Crucial and is supposed to be as above spec. I don't want to email them just yet incase I have missed something simple.
Anyone got any ideas?
The mother board is a 993AS it has 3 Dimm slots and according to the motherboard manual it supports up to 3x168pin sdram modules with ecc pc133 and run at 133 or 150 mhz and the max capacity is 1.5GB
I've had a look in the bios and dont see anything that can be changed apart from the Ecc enable or disable.
memory was purchased from Crucial and is supposed to be as above spec. I don't want to email them just yet incase I have missed something simple.
Anyone got any ideas?