2005 auris

[felix17popa]

I have a Toyota Auris
immo 89780-02040
ecu 89661-02E51

immo light goes off, car start and cut off after few seconds
there is no DTC set in the immo, nor in the ECU, suspect it may be out of synch.
can anyone check attached file and confirm this?

thx

[darrenhyland]

try bridging pin 4 and 13 on obd connector for 30 mins

[felix17popa]

Done that and same issue.....this is a 4d 70 key.....it behave like out of synch...

[achaccha]

It's true friend, you are right its archvos are not synchronized.
Please install everything in place and make a bridge between 4 and 13 pin OBDII for 30 minutes.
luck

[felix17popa]

As I said, I have bridged 4 and 13 for over 30 min before and nothing changed. What I was saying is that maybe this one would not synch in this way

[achaccha]

Dear friend.
I suspect you have a problem in the wiring, I made ;several pairings with this method and there is no problem. in South America this vehicle is similar to the Toyota Corolla with key 4D70. in my workshop there have been several of these vehicles with great success.
regards

[felix17popa]

Thx for this, unfortunately is nothing wrong with the wiring....only hope that someone here can confirm or not if synch is OK on the attached files, otherwise maybe someone will help me with virgin files...

[bram380]

can you post here key data?

but try this dump (pm)

[keygargoil]

I have a Toyota Auris
immo 89780-02040
ecu 89661-02E51

immo light goes off, car start and cut off after few seconds
there is no DTC set in the immo, nor in the ECU, suspect it may be out of synch.
can anyone check attached file and confirm this?

thx

what are you reading the fault codes with there isnt anything wrong with your files they are in sync it seems like this maybe fuel related either the pump etc have you checked for the cut of

[achaccha]

Dear friend.
I do not see a problem in your file, but friend, if you interrogate the engine computer and says that no fault codes, it means that all is well on that side.
if there is a matching problem between the ECU and the immo you should leave a code fails as B2799.
See if spark plugs are working well and also the fuel system that will help a lot
regards

[felix17popa]

thx for this info!
it seems that this car has a stop and start system, anyone has a diagram of such? it may be a possible cause of engine cutting after few seconds...