PDA

View Full Version : Advice for Alfa 147 jtdm 120 cv



kobelco
17th August, 2012, 04:14 PM
Hello everyone!

Someone can make suggestions for this dump?

Alfa 147 jtdm 8v 120cv.
Read with Kessv2 and modified with ECM titanium.

Thanks in advance
Regards

mario38
17th August, 2012, 04:24 PM
Your file is very far from a good change ...
example egr off is not ok
lacks many important maps and those that you have done are done wrong ..
attention to possible clogging fap

kobelco
17th August, 2012, 04:31 PM
Your file is very far from a good change ...
example egr off is not ok
lacks many important maps and those that you have done are done wrong ..
attention to possible clogging fap

Thanks for the reply.
Where do I improve?

The car does not have the Dpf.

thanks

ominimicu
17th August, 2012, 07:40 PM
too much torque, too much turbo you should never go above 2300 mbar, the turbo limiter is too high,, so you wont get to limp mode...but you could damage the turbo, make sure the manufacturer allows that much pressure.

too much rail pressure. noo need for that.

Dont close EGR is bad, and you are missing so many maps