javiercj
20th August, 2012, 09:37 AM
Hello friends.
I have to cancel that out the error in the weight of occupation of the fiat stylo sensor box.
Am going to use emulator,
well the issue is that I have drawn the connection tab and the emulator has to enter three cable:br
positive (+12V) ground (negative) - data
.Do
have tested with tester and it is that the connector gets it:
2 wires positive
1 ground cable
question e:
is which of the two wires with positive data?.
This check with tester I've done with the contact post.
Because without the contact since, only one of them is mass, the rest does not have voltage.
Can someone tell me which of the two positive wires is the signal?
thank you
I have to cancel that out the error in the weight of occupation of the fiat stylo sensor box.
Am going to use emulator,
well the issue is that I have drawn the connection tab and the emulator has to enter three cable:br
positive (+12V) ground (negative) - data
.Do
have tested with tester and it is that the connector gets it:
2 wires positive
1 ground cable
question e:
is which of the two wires with positive data?.
This check with tester I've done with the contact post.
Because without the contact since, only one of them is mass, the rest does not have voltage.
Can someone tell me which of the two positive wires is the signal?
thank you