PDA

View Full Version : galletto original whith iaw59f



javilette
29th August, 2012, 04:52 PM
works fine this tool whith iaw59f.m3 hw 303 i need remove the immo or clone of the other one. i try to read i put
34, 10 . GND
16 . k line
4, 17 . +
and i put boot mode whith GND to the hole of the ecu , i khow where is the pin of boot mode is ok this.

i dont khow isf this ecu have
ST10f168 or ST10f269 i try whith two driver but dont works

can somebody help me

eprommazza
29th August, 2012, 05:00 PM
works fine this tool whith iaw59f.m3 hw 303 i need remove the immo or clone of the other one. i try to read i put
34, 10 . GND
16 . k line
4, 17 . +
and i put boot mode whith GND to the hole of the ecu , i khow where is the pin of boot mode is ok this.

i dont khow isf this ecu have
ST10f168 or ST10f269 i try whith two driver but dont works

can somebody help me

m3 _ 303 have st10f168 best regards

javilette
29th August, 2012, 10:05 PM
thank you eprom mazza works ok galleto whith this ?????

eprommazza
30th August, 2012, 05:26 AM
thank you eprom mazza works ok galleto whith this ?????

yes work ok
can use (clona and decode) for make virgin this ecu..
is not the maximum fg tech for this ecu ..

best regards

javilette
30th August, 2012, 04:21 PM
can i use this sw whith gallletto????? for clone ecu works whis flash file or i need use tool with st10f168 boot mode???

javilette
30th August, 2012, 05:14 PM
can i read flash file and by boot mode but when i try to write , i cant write by k line and boot mode too , if i try in the car can i wirte the file by obd?????

eprommazza
31st August, 2012, 06:52 AM
boot mode you read file size 320kb eeprom+flash all in one
select (clona e decode) this do your file virgin when write in automatic!!

br