PDA

View Full Version : Golf_EDC16 Hot_start



Manum50
1st September, 2012, 11:48 AM
I need to do hot start for this car. What kind of maps I have to work? Dependence then what? I think it's two cards 9x9. But what lies on the X axis and the axis Y? I think one of them the temperature?
Thanks.

Fec001
1st September, 2012, 11:53 AM
post pictures about maps

Manum50
1st September, 2012, 12:20 PM
http://s56.radikal.ru/i151/1209/c1/feb760786f2f.jpg (http://www.radikal.ru)
Is it ok?

Manum50
1st September, 2012, 12:51 PM
May be that

70max
1st September, 2012, 01:10 PM
May be that

Hi,

Here is the file stat hot fixes and EGR Off

CKS OK


Pass PM

regards Max

Manum50
1st September, 2012, 01:21 PM
PM doesn't work
And what lies on the X axis and the axis Yon these two maps?

70max
1st September, 2012, 01:28 PM
PM doesn't work
And what lies on the X axis and the axis Yon these two maps?


PM is working

Look Good

greetings

Manum50
1st September, 2012, 01:37 PM
I tried I can't open

70max
1st September, 2012, 01:45 PM
Manum50


But you showed in the special section of Presentation?

I did not see your post

Fec001
1st September, 2012, 02:29 PM
PM doesn't work
And what lies on the X axis and the axis Yon these two maps?

Try this. without pass

Manum50
1st September, 2012, 04:08 PM
Thanks.
This dependence of the temperature and RPM and.......?

Fec001
1st September, 2012, 04:35 PM
yes. and don't forget to use "the button"

Manum50
1st September, 2012, 04:48 PM
But the third value?You haven't named.
What's name of this map

Fec001
2nd September, 2012, 03:34 AM
output of the map is IQ.

Manum50
2nd September, 2012, 05:59 AM
Injection quantity? Correction of fuel at the start of?

Fec001
2nd September, 2012, 10:46 AM
InjectED quantity at the start depend on RPM and temperature.

spawns3
2nd September, 2012, 11:06 AM
InjectED quantity at the start depend on RPM and temperature.

On edc15 is quantity in Mg , in edc16 the map value is NM . And if u want to see the ?c u have to put on x-axis factor 0.1/and the offset -273.1400
Y axis is RPM .

Fec001
3rd September, 2012, 10:56 AM
On edc15 is quantity in Mg , in edc16 the map value is NM . And if u want to see the ?c u have to put on x-axis factor 0.1/and the offset -273.1400
Y axis is RPM .

Right, sorry I missed that this ECU is 16