BMW EWS3 1997

[yusef]

need help with this immobelised bmw 525i petrol 1997 model.


fault code in engine ecu
18 EWS SIGNAL ; not present or faulty/signal camshaft ms43

no fault codes in EWS

READ KEY
data 5507358A59D3AD75AC941DB403DD018E
KNR 7
KMS 857941
VIN "aaaaaa]aaaaaaaa"
vin WBADD42080BV11824

another old key not used for long time
data 55052e836b563048a87a789403dd018e
KNR 5
km 150922
vin wbadd42080bv1182k

read EWS MC68HC11EA9 2D47J (attached dump bmw original.rar)
It reads all Ff

CAR DETAILS
VIN WBADD42080BV11824
MILES 123909

used ews editor ; EWS 3 ;factory with above key data ; see attach EWS edited

Put back EWS with edited data in MC68HCEA9 - SYNC DDE - EWS ; tried but still immobelised
not sure about dme>><<dme data at bottom of editor

PLEASE HELP ; appreciate if somebody would send edited data to match above vin, mileage, key data etc
Just realised that put mileage without converting to Kms - dont know if this would stop from starting ?

Thanks

[koncimobil]

Read isn dme & put it to ews.
or
read flash dme, i will give the isn.

[yusef]

Read isn dme & put it to ews.
or
read flash dme, i will give the isn.

Is it possible to read isn in dme through obd or reflash dme through obd ?

Which chip do i need to read in dme ?

thanks

[koncimobil]

try read isn dme with inpa.
or read with eprom programmer.
flash 29Fxxx PSOP44

[yusef]

read ISN number with inpa in DME as a42

tried reading ISN number,password in EWS and comes with "error - ecu - rejected "

tried writting ISN with inpa "<F1> writing ISN number and nothing happens "

cant go forward putting ISN through obd

maybe can somebody write in EWS MC68HC11EA9

thanks

[verica]

you have isn code

[verica]

why dont you make immo off whot ecu you have in the car bosch or siemens

[yusef]

seimens ecu
dont have programmer to read 28F200
just got new EWS and new key from dealers
going to fit now, hopefully matter of sync dme